what is a store buffer?

44
votes

can anyone explain what is load buffer and how it's different from invalidation queues. and also difference between store buffers and write combining buffers? The paper by Paul E Mckenny http://www.rdrop.com/users/paulmck/scalability/paper/whymb.2010.07.23a.pdf explains very nicely about the store buffers and invalidation queues but unfortunately doesn't talk about write combining buffers

1
architecturehardwareintelcpu-architecture
See also Size of store buffers on Intel hardware? What exactly is a store buffer? – Peter Cordes
Also this more successful (IMO) attempt at describing what a store buffer is and what it does, I think more beginner-friendly. – Peter Cordes

1 Answers

44
votes

An invalidate queue is more like a store buffer, but it's part of the memory system, not the CPU. Basically it is a queue that keeps track of invalidations and ensures that they complete properly so that a cache can take ownership of a cache line so it can then write that line. A load queue is a speculative structure that keeps track of in-flight loads in the out of order processor. For example, the following can occur

  1. CPU speculatively issue a load from X
  2. That load was in program order after a store to Y, but the address of Y is not resolved yet, so the store does not proceed.
  3. Y is resolved and it turns out to be equal to X. At the time that the store to Y is resolved, that store searches the load queue for speculative loads that have issued, but are present after the store to Y in program order. It will notice the load to X (which is equal to Y) and have to squash those instructions starting with load X and following.

A store buffer is a speculative structure that exists in the CPU, just like the load queue and is for allowing the CPU to speculate on stores. A write combining buffer is part of the memory system and essentially takes a bunch of small writes (think 8 byte writes) and packs them into a single larger transaction (a 64-byte cache line) before sending them to the memory system. These writes are not speculative and are part of the coherence protocol. The goal is to save bus bandwidth. Typically, a write combining buffer is used for uncached writes to I/O devices (often for graphics cards). It's typical in I/O devices to do a bunch of programming of device registers by doing 8 byte writes and the write combining buffer allows those writes to be combined into larger transactions when shipping them out past the cache.