Maximum Flow in Dynamic graphs

10
votes

I'm looking for fast algorithm to compute maximum flow in dynamic graphs (adding/deleting node with related edges to graph). i.e we have maximum flow in G now new node added/deleted with related edges, I don't like to recalculate maximum flow for new graph, in fact, I want use previous available results for this graph.

Any preprocessing which isn't very time/memory consumer is appropriated.

Simplest idea is recalculating the flow.

Another simple idea is as this, save all augmenting paths which used in previous maxflow calculation, now for adding vertex v, we can find simple paths (in updated capacity graph by previous step) which start from source, goes to v then goes to destination, but problem is this path should be simple, I couldn't find better than O(n*E) for this case. (if it was just one path or paths was disjoint, this can be done in O(n+E), but it's not so).

Also for removing node above idea doesn't work.

Also my question is not related to another question which looks on dynamic edges adding/removing.

3
algorithmgraphmax-flow
How is your question not related to the link you gave? It seems spot on to me. - Keith Randall
@KeithRandall, my question is about adding deleting vertex, but that question was about edges, in fact with one vertex you probably will add n edges, so vertex case is more complicated than edge case, e.g I can have some intuition with edges, but my best solution for vertices is not good solution. - Saeed Amiri
@Charles, would you describe why you removed max-flow tag? I added this tag to SO because it's useful. specially in searches. - Saeed Amiri
edges are what matters, adding or removing a vertex with no edges is trivial. So maybe you're asking if there is a more efficient incremental algorithm to add n edges all connected to a single vertex, than running the linked incremental edge algorithm n times? - Keith Randall
@Saeed, the term "maximum flow" is generic and ill-defined to outsiders. Perhaps consider adding a tag wiki, picking a more precise name for the tag (maybe "maximum-flow" instead of just "max-flow"?), and going through other questions here on SO and adding it where relevant. Taking these steps will dissuade new tag deletionists such as myself from removing it in the future. - Charles

3 Answers

1
votes

For adding Vertex v,Use the old Flow f and compute the Residual Graph, then get an Augmenting Path by DFS OutDeg(v) times.

For removing a Vertex v - compute all the flow thats leaving v, say the sum of flow leaving v is a, then while (a>0) find a path P from s to t that is going thro v, and reduce f(P) from the flow and from a.

i think that should help... im more sure on the addition then on the remove, so id love to get corrected in comments :)

0
votes

To dynamically add a vertex v and its associated edges E:

1) Add v by itself to the graph. Since it has no edges, it cannot affect the maximum flow.

2) Add the associated edges E to the graph, one at a time, using the algorithm from this question

Do the reverse for deleting a vertex and its associated edges.

0
votes

I asked this question in CSTheory.StackExchange, For Adding node as I discussed with others I found recalculating is faster than other known algorithms, because recalculation runs on semi sparse graph (residual graph) so it's fast enough also for removing node, there was a good answer, dividing node (which wants to be removed) into two sets, v_in and v_out and calculating flow on residual graph from v_in to v_out, and again calculating flow in residual graph from v_in to v_out by adding infinite edge between source and destination. (and finally comparing their difference and updating residual graph). You can see related Q/A and discussions in Incremental Maximum Flow in Dynamic graphs.