How do I increase the scrollback buffer in a running screen session?

Question

Lets say I have a currently running screen session I am interacting with through putty. I've realized that the scrollback buffer is too small and would like to increase it without starting a new screen session.

Is there a way to do this?

Answer 1

The man page explains that you can enter command line mode in a running session by typing Ctrl+A, :, then issuing the scrollback <num> command.

Answer 2

Press Ctrl-a then : and then type

scrollback 10000

to get a 10000 line buffer, for example.

You can also set the default number of scrollback lines by adding

defscrollback 10000

to your ~/.screenrc file.

To scroll (if your terminal doesn't allow you to by default), press Ctrl-a ESC and then scroll (with the usual Ctrl-f for next page or Ctrl-a for previous page, or just with your mouse wheel / two-fingers). To exit the scrolling mode, just press ESC.

Another tip: Ctrl-a i shows your current buffer setting.

Answer 3

There is a minimal amount of "default" buffer when you startup a 'screen' session within your 'putty session'. I use screens a lot in my work, so I can tell you that you will not have a combination of 'screen' buffer & 'putty' buffer within your 'screen' session.

Setting the default number of scrollback lines by adding defscrollback 10000 to your ~/.screenrc file is the correct solution.

By the way, I use "defscrollback 200000" in my ./screenrc file.

Answer 4

As Already mentioned we have two ways!

 Per screen (session) interactive setting

And it's done interactively! And take effect immediately!

CTRL + A followed by : And we type scrollback 1000000 And hit ENTER

You detach from the screen and come back! It will be always the same.

You open another new screen! And the value is reset again to default! So it's not a global setting!

 And the permanent default setting

Which is done by adding defscrollback 1000000 to .screenrc (in home)

defscrollback and not scrollback (def stand for default)

What you need to know is if the file is not created ! You create it !

> cd ~ && vim .screenrc

And you add defscrollback 1000000 to it!

Or in one command

> echo "defscrollback 1000000" >> .screenrc

(if not created already)

Taking effect

When you add the default to .screenrc! The already running screen at re-attach will not take effect! The .screenrc run at the screen creation! And it make sense! Just as with a normal console and shell launch!

And all the new created screens will have the set value!

Checking the screen effective buffer size

To check type CTRL + A followed by i

And The result will be as

Importantly the buffer size is the number after the + sign
(in the illustration i set it to 1 000 000)

Note too that when you change it interactively! The effect is immediate and take over the default value!

Scrolling

CTRL+ A followed by ESC (to enter the copy mode).

Then navigate with Up,Down or PgUp PgDown

And ESC again to quit that mode.

(Extra info: to copy hit ENTER to start selecting! Then ENTER again to copy! Simple and cool)

Now the buffer is bigger!

And that's sum it up for the important details!

Answer 5

WARNING: setting this value too high may cause your system to experience a significant hiccup. 
The higher the value you set, the more virtual memory is allocated to the screen process when initiating the screen session. 

I set my ~/.screenrc to "defscrollback 123456789" and when I initiated a screen, my entire system froze up for a good 10 minutes before coming back to the point that I was able to kill the screen process (which was consuming 16.6GB of VIRT mem by then).