I have just recently started to use MATLAB to acquire data off of a data acquisition board and was in need of a function to acquire data continuously (i.e. until I ctrl^C out of the function). To do this I am using the data acquisition toolbox on a 32-bit windows OS.
Based on the documentation in matlab help and a few of the answers on this site, I found that after adding channels to my input handle I should:
- set my 'SamplesPerTrigger' to Inf
- set the 'TimerPeriod' to some value to trigger the 'TimerFcn'
- set the 'TimerFcn' to some subfunction callback which appends data to a persistent variable
Is this a correct way to do this?
My code is as follows:
function acquire_arena_test(samprate,daq_device ,device_ID ,channels, saveroot)
setup.SampleRate = samprate;
setup.DAQdevice = {daq_device, device_ID};
setup.AIChannels = channels;
setup.SaveRoot = {saveroot};
ai = analoginput(setup.DAQdevice{1},setup.DAQdevice{2});
addchannel(ai,[setup.AIChannels]);
set(ai,'SamplesPerTrigger',Inf);
set(ai,'TimerPeriod',0.5);
set(ai,'TimerFcn',{@AcquireData,ai});
start(ai);
while(strcmpi(get(ai,'Running'),'On'))
pause(1)
end
stop(ai);
time = datestr(now,30);
save([saveroot time], 'data');
delete(ai);
clear ai;
function AcquireData(hObject, ~)
persistent totalData;
data = getdata(hObject);
if isempty(totalData)
totalData =data;
else
totalData = [totalData; data];
end
The initial analog input is definitely working properly. I have tried many permutations of giving the AcquireData callback to 'TimerFcn'. The error I receive is
`??? Error using ==> acquire_arena_test>AcquireData Too many input arguments.
Warning: The TimerFcn callback is being disabled. To enable the callback, set the TimerFcn property. `
Thanks in advance for any help.
acquire_arena_test(1000,'nidaq','Dev1',[0:7], 'C:\....\')
after runningdaqreset
andclear all
. The 8 channels do receive input, because if I comment out the 'SamplesPerTrigger' I get an output file saved in my saveroot. – St-Ste-Ste-Stephen