I have a problem using Raspbery Pi hardware and Simulink, shown by the pictures below.
I'm tring to control an LED and GPIO pin on the Raspberry Pi.
- I click Build, Deploy & Start. It works.
- But then I click Monitor & Tune for monitoring signals.
It produces an error which I cannot find a solution for.
I tried different versions of Matlab but got the same error.
My hardware settings are just like in this link: https://www.mathworks.com/help/supportpkg/raspberrypi/examples/communicating-with-raspberry-pi-hardware.html
In addition I tried to click connect on external mode panel and the result is the same, the error is same.
Do you have any suggestions?
[Cross posted from Matlab Answers].
