Hi i am trying to set up my git Bash enviroment with vagrant via virtualBox but i am unsuccessfull. I am trying to open localhost:8080/xxxx, but it just loads and I think this is because this
I have the latest versions of both vagrant and virtualBox. My commands: "cd fullstack/vagrant", "vagrant up"
but then i get the following :
Bringing machine 'default' up with 'virtualbox' provider... ==> default: Checking if box 'bento/ubuntu-16.04' is up to date... ==> default: Clearing any previously set forwarded ports... ==> default: Clearing any previously set network interfaces... ==> default: Preparing network interfaces based on configuration... default: Adapter 1: nat ==> default: Forwarding ports... default: 8000 (guest) => 8000 (host) (adapter 1) default: 8080 (guest) => 8080 (host) (adapter 1) default: 5000 (guest) => 5000 (host) (adapter 1) default: 22 (guest) => 2222 (host) (adapter 1) ==> default: Running 'pre-boot' VM customizations... ==> default: Booting VM... ==> default: Waiting for machine to boot. This may take a few minutes... default: SSH address: 127.0.0.1:2222 default: SSH username: vagrant default: SSH auth method: private key Timed out while waiting for the machine to boot. This means that Vagrant was unable to communicate with the guest machine within the configured ("config.vm.boot_timeout" value) time period.
If you look above, you should be able to see the error(s) that Vagrant had when attempting to connect to the machine. These errors are usually good hints as to what may be wrong.
If you're using a custom box, make sure that networking is properly working and you're able to connect to the machine. It is a common problem that networking isn't setup properly in these boxes. Verify that authentication configurations are also setup properly, as well.
If the box appears to be booting properly, you may want to increase the timeout ("config.vm.boot_timeout") value.
