I am working with time-critical applications where the microsecond counts. I am interested to a more convenient way to develop my applications using a non bare-metal approach (some kind of framework or base foundation common to all my projects).
A considered real-time operating system such as RTX, Xenomai, Micrium or VXWorks are not really real-time under my terms (or under the terms of electronic engineers). So I prefer to talk about soft-real-time and hard-real-time applications. An hard-real-time application has an acceptable jitter less than 100 ns and a heat-beat of 100..500 microseconds (tick timer).
After lots of readings about operating systems I realized that typical tick-time is 1 to 10 milliseconds and only one task can be executed each tick. Therefore the tasks take usually much more than one tick to complete and this is the case of most available operating systems or micro kernels.
For my applications a typical task has a duration of 10..100 microseconds, with few exceptions that can last for more than one tick. So any real-time operating system cannot not fulfill my requirements. That is the reason why other engineers still not consider operating system, micro or nano kernels because the way they work is too far from their needs. I still want to struggle a bit and in my case I now realize I have to consider a new category of operating system that I never heard about (and that may not exist yet). Let's call this category nano-kernel or subtick-scheduler
In such dreamed kernels I would find:
- 2 types of tasks:
- Preemptive tasks (that run in their own memory space)
- Non-preemptive tasks (that run in the kernel space and must complete in less than one tick.
- Deterministic kernel scheduler (fixed duration after the ISR to reach the theoretical zero second jitter)
- Ability to run multiple tasks per tick
For a better understanding of what I am looking for I made this figure below that represents the two types or kernels. The first representation is the traditional kernel. A task executes at each tick and it may interrupt the kernel with a system call that invoke a full context switch.
The second diagram shows a sub-tick kernel scheduler where multiple tasks may share the same tick interrupt. Task 1 was summoned with a maximum execution time value so it needs 2 ticks to complete. Task 2 is set with low priority, so it consumes the remaining time of each tick upon completion. Task 3 is non-preemptive so it operates on the kernel space which save some precious context switch time.
Available operating systems such as RTOS, RTAI, VxWorks or µC/OS are not fully real-time and are not suitable for embedded hard real-time applications such as motion-control where a typical cycle would last no more than 50 to 500 microseconds. By analyzing my needs I land on different topology for my scheduler were multiple tasks can be executed under the same tick interrupt. Obviously I am not the only one with this kind of need and my problem might simply be a kind of X-Y problem. So said differently I am not really looking at what I am really looking for.
After this (pretty) long introduction I can formulate my question:
What could be a good existing architecture or framework that can fulfill my requirements other than a naive bare-metal approach where everything is written sequentially around one master interrupt? If this kind of framework/design pattern exists what would it be called?