Cannot install windows service

Question

I have created a very simple window service using visual studio 2010 and .NُET 4.0.

This service has no functionality added from the default windows service project, other than an installer has been added.

If I run "installutil.exe appName.exe" on my dev box or other windows 2008 R2 machines in our domain the windows service installs without issue.

When I try to do this same thing on our customer site, it fails to install with the following error.

Microsoft (R) .NET Framework Installation utility Version 4.0.30319.1
Copyright (c) Microsoft Corporation.  All rights reserved.

Exception occurred while initializing the installation:
System.IO.FileLoadException: Could not load file or assembly 'file:///C:\TestService\WindowsService1.exe' or one of its dependencies. Operation is not supported. (Exception from HRESULT: 0x80131515).

This solution has only 1 project and no dependencies added.

I have tried it on multiple machines in our environment and two in our customers. The machines are all windows 2008 R2, both fresh installs. One machine has just .net 2.0 and .net 4.0. The other .net 2, 3, 3.5 and 4.

I am a local admin on each of the machines.

I have also tried the 64bit installer but get the following error, so I think the 32 bit one is the one to use. System.BadImageFormatException

Any guidance would be appreciated. Thanks.

Answer 1

Another reason for this error might be that you copied your program from a source which windows considers untrusted. You can unblock the assembly by clicking "unblock" after you right-click and select properties on the file.

Answer 2

Need to unblock files. or at least that's what fixed mine.

To do 'bulk' unblock in Powershell

get-childitem *.* | Unblock-File 

or in DOS:

FOR %a in (*.*) do (echo.>%a:Zone.Identifier)

Answer 3

When we copy executable from another computer, Windows mark a flag on them for protection. Right Click on executable and in properties Click Unblock. It would clear flag and service executable would Install.

Answer 4

This issue came about for me because I was trying to install the service from a network location. By copying the service.exe to the local machine prior to using installutil, it fixed my problem and the service installed successfully.

Answer 5

don't forget to vote up... Try the SC as follows: 1. open command line 2. write the below- sc create ServiceName BinPath= "ExePath". report on results...

Answer 6

I also faced the same issue. In my case I was deploying new version of utilities , i copied new exe , installog files and then trying to uninstall the utils.

I copied back the old version , uninstal the utils , copied the new version and installed it again. Anyway it is the logical sequence I should have followed in first place.

Answer 7

i have this issue and it for different between of .net version of util and my service
i use util for .net 2 and my service build with .net4

Answer 8

In my case this error was caused by accidentally passing the directory containing the service to InstallUtil instead of passing the service exe.

Obviously human error but I found the error message quite misleading.

Answer 9

you can use this command in developer command prompt run administrator

installutil C:\...\MyService\bin\Debug\MyService.exe

Answer 10

As per @doublehelix's response above, this answer put me on track for my particular issue which related to a service issue running in Windows XP (Unblock is not an option in the security tab that I could find). In my case I was attempting to run a service from a separate drive (i.e. not on the same drive as Windows and not under program files) although the actual physical disk was the same. Moving my service into the Program Files folder solved my underlying issue. (I intended to 'comment' against @doublehelix's answer but I don't seem to be able to in my current status).

Answer 11

You can try to make a Setup Project for your service and run the MSI file on that server.