Why “No NFC device found” with libnfc and PN532 SHIELD

3
votes

I installed the libnfc on my ArchLinux and i would use it through my Adafruit PN532 arduino SHIELD.

nfc-list returns me the message "No NFC device found".

I have the following file in /etc/nfc/devices.d/pn532.conf that gives me

nfc-list uses libnfc 1.7.1 error libnfc.driver.pn532_uart pn53x_check_communication error error libnfc.chip.pn53x Unexpected PN53x reply! nfc-list: ERROR: Unable to open NFC device: pn532_uart:/dev/ttyACM0

Any idea about how to fix that ? TY

2
arduinonfclib-nfcadafruit
Are you sure you have the cable RX/TX properly setup? Are you able to use the NFC shield with an arduino? - sebastienvg
I am able to use the shield with the arduino. My problem is referring to the lib imo - user5329034

2 Answers

3
votes

First of all verify your Rx/Tx connections.

And then Configure LIBNFC with following command :

1) ./configure --with-drivers=pn532_uart --sysconfdir=/etc --prefix=/usr --enable-serial-autoprobe

2) make clean all

3) sudo make install all

And Finally 4) LIBNFC_LOG_LEVEL=3

Now Try 5) nfc-list

If Still problem persists try this tutorial from nfc-tool

Source/Reference

1
votes

For me it worked to swap the RX <-> TX