Cannot connect with SIP using Asterisk

Question

I configured SIP connection with Asterisk. Server is running successfully but when i try to connect sip with X-Lite. Its giving Sip Error 408.

disallow=all                    ; First disallow all codecs
allow=ulaw                      ; Allow codecs in order of preference


externip = **.**.***.***; Address that we're going to put in outbound SIP
                            ; messages if we're behind a NAT


;localnet=192.168.0.0/255.255.0.0; All RFC 1918 addresses are local networks
localnet=10.0.0.0/255.0.0.0     ; Also RFC1918
;localnet=172.16.0.0/12         ; Another RFC1918 with CIDR notation
;localnet=169.254.0.0/255.255.0.0 ;Zero conf local network


nat=route                               ; Global NAT settings  (Affects all peers and users)
                            ; yes = Always ignore info and assume NAT
                            ; no = Use NAT mode only according to RFC3581 (;rport)
                            ; never = Never attempt NAT mode or RFC3581 support
                            ; route = Assume NAT, don't send rport
                            ; (work around more UNIDEN bugs)

This is my sip.conf file

and my extensions.conf is:

exten => *98,1,VoiceMailMain
exten => *98,2,Hangup

Please check the details and help me to connect. THANKS

Istvan Istvan · Accepted Answer · 2016-04-13T12:23:06

If you are using Asterisk 13 then you should configure the extensions in pjsip.conf (and not in sip.conf file). Asterisk 13 have moved to pjsip.

Otherwise the error code 408 means "Request Timeout" so most probably X-Lite doesn't receive any answer for the REGISTER request. Double check your IP/port/NAT configurations.

If still doesn't then you should have a look at the logs. (Enable logs by sipdebug=yes and in logger.conf set the Verbose config to "notice,warning,error,debug,verbose,dtmf" below the [logfiles] section)

Cannot connect with SIP using Asterisk

1 Answers