How to plot the magnitude and phase of a frequency?

0
votes

I was reading Practical Introduction to Frequency Domain Analysis. It shows how to observe the frequency content of a signal using this code:

Fs = 44100;
y = audioread('guitartune.wav');

NFFT = length(y);
Y = fft(y,NFFT);
F = ((0:1/NFFT:1-1/NFFT)*Fs).';

magnitudeY = abs(Y);        % Magnitude of the FFT
phaseY = unwrap(angle(Y));  % Phase of the FFT

helperFrequencyAnalysisPlot1(F,magnitudeY,phaseY,NFFT)

The function that plots is the helperFrequencyAnalysisPlot1. I need to know how the function does the plotting but the article never shows how. How is it actually done?

1
matlabplotsignal-processingfftfrequency-domain
Would edit helperFrequencyAnalysisPlot1 show you the code? – mikkola

1 Answers

2
votes

These are Matlab built-in examples so you have to type in the Command Window

edit('helperFrequencyAnalysisPlot1.m')

A new Matlab editor tab will pop up, showing you the function (both its definition and the code).