How to detect the path for usb in QNX

Question

How we can detect that USB (pen drive) is under which path? For one of our issue device was connected to /dev/ttyUSB1 instead of /dev/ttyUSB0.

How we can detect that where device is connected? Is there any command i QNX so that we can use that to detect the path of usb?

USB mass storage should mount on /dev/usb* and not /dev/ttyUSB*. Please check the mcd.conf file. You will see the paths. — Shaibal
@Shaibal I can see that in ttyUSB0 or ttyUSB1 and in another device /dev/umass0t11. There is not /dev/usb* path. which path can I see mcd.conf file? — Swapnil

Shaibal Shaibal · Accepted Answer · 2016-01-28T09:44:57

Please follow this thread. This will solve your problem I hope.