STM32 external interrupt keeps triggering

Question

I am trying to use a rotary encoder and button with an STM32F103 and FreeRTOS. The external interrupts for a pin0 and pin1 work fine but the button is connected to a Pin13 (EXTI15_10_IRQHandler) which keeps triggering without cause. Of course, I could just use a pin2 (EXTI2_IRQHandler) to 4 or poll the button pin without interrupt but I would like to know the cause of this. What am I missing here?

    // button
#define ROEN_BUTTON_GPIO        GPIOC
#define ROEN_BUTTON_PIN         GPIO_Pin_13

    // init method

    NVIC_InitTypeDef NVIC_InitStruct;
    EXTI_InitTypeDef EXTI_InitStruct;
    GPIO_InitTypeDef GPIO_InitStructure;
    GPIO_StructInit(&GPIO_InitStructure);

   /**
    * GPIO configuration
    * Configure pins as input w/ pullup
    */
    GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IPU;  
    GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
    GPIO_InitStructure.GPIO_Pin = ROEN_BUTTON_PIN;      // Button
    GPIO_Init(ROEN_BUTTON_GPIO, &GPIO_InitStructure);

    /* Tell system that you will use PC13 for EXTI_Line13 */
    GPIO_EXTILineConfig(GPIO_PortSourceGPIOC, EXTI_Line13);

    /* Enable interrupt */
    EXTI_InitStruct.EXTI_LineCmd = ENABLE;
    /* Interrupt mode */
    EXTI_InitStruct.EXTI_Mode = EXTI_Mode_Interrupt;
    /* Triggers on rising and falling edge */
    EXTI_InitStruct.EXTI_Trigger = EXTI_Trigger_Falling;
    /* PC13 is connected to EXTI_Line13 */
    EXTI_InitStruct.EXTI_Line    = EXTI_Line13;
    EXTI_Init(&EXTI_InitStruct);


    /* Enable interrupt */
    NVIC_InitStruct.NVIC_IRQChannelCmd = ENABLE;
    NVIC_InitStruct.NVIC_IRQChannel = EXTI15_10_IRQn;
    /* Set priority */
    NVIC_InitStruct.NVIC_IRQChannelPreemptionPriority = 0x03;
    /* Add to NVIC */
    NVIC_Init(&NVIC_InitStruct);


/* Handle PC13 interrupt */
void EXTI15_10_IRQHandler(void) {
    /* Make sure that interrupt flag is set */
    if (EXTI_GetITStatus(EXTI_Line13) != RESET) {
        /* Clear interrupt flag */
        EXTI_ClearITPendingBit(EXTI_Line13);
    }
}

RootRaven RootRaven · Accepted Answer · 2015-03-19T16:20:40

I found the error with an additional compiler warning:

void GPIO_EXTILineConfig(uint8_t GPIO_PortSource, uint8_t GPIO_PinSource);

I used the wrong macro for GPIO_PinSource, it has to be

GPIO_EXTILineConfig(GPIO_PortSourceGPIOC, GPIO_PinSource13);

STM32 external interrupt keeps triggering

1 Answers