Setting SLIME in emacs

Question

I was trying to install SLIME. I downloaded the zipped package and according to the README file, I have to put this piece of code in my Emacs configuration file:

(add-to-list 'load-path "~/hacking/lisp/slime/")  ; your SLIME directory
(setq inferior-lisp-program "/opt/sbcl/bin/sbcl") ; your Lisp system
(require 'slime)
(slime-setup)

Setting the SLIME directory is straightforward, but what about the Lisp "system"? How do I find it?

Unknown Unknown · Accepted Answer · 2012-09-26T19:33:06

Some Linuxes come with CMUCL preinstalled, but since you seem to want to use SBCL, you would need to install it.

In terminal, or in Emacs M-xshell. If you are using Debian-like distro, you can use apt-get or aptitude with the following:

$ sudo apt-get install sbcl

or

$ sudo aptitude install sbcl

on RHEL-like distro:

$ sudo yum install sbcl

After SBCL is installed, you can set inferior-lisp-program to "sbcl".

Also, I'd advise to install SLIME through quicklisp-slime-helper

You would need to install some Lisp you like (let it be SBCL for this purpose, as described above), then, in the same shell do this:

(Suppose you are on a Debian-like Linux)

$ sudo apt-get install wget
$ cd ~/Downloads
$ wget http://beta.quicklisp.org/quicklisp.lisp
$ sbcl --load ./quicklisp.lisp

wait until you see Lisp shell prompt,

* (quicklisp-quickstart:install)
* (ql:add-to-init-file)
* (ql:quickload "quicklisp-slime-helper")
* (quit)

now you are back in the regular shell. Launch Emacs, if not open yet. C-f x~/.emacs. Add the lines below to it (instead of what you posted above):

(load (expand-file-name "~/quicklisp/slime-helper.el"))
(setq inferior-lisp-program "sbcl")

Or replace "sbcl" with the Lisp implementation you installed.

Look into Quicklisp documentation for more information. You will find that you will be using Quicklisp later anyway, so it's useful you get it all in one place from the start.

Setting SLIME in emacs

2 Answers