An error occurred (InvalidParameterException) when calling the PutSubscriptionFilter operation

Question

Trying to put cloud watch logs into kineses firehose.

Followed below: https://docs.aws.amazon.com/AmazonCloudWatch/latest/logs/SubscriptionFilters.html#FirehoseExample

Got this error

An error occurred (InvalidParameterException) when calling the PutSubscriptionFilter operation: Could not deliver test message to specified Firehose stream. Check if t e given Firehose stream is in ACTIVE state.

aws logs put-subscription-filter --log-group-name "xxxx" --filter-name "xxx" --filter-pattern "{$.httpMethod = GET}" --destination-arn "arn:aws:firehose:us-east-1:12345567:deliverystream/xxxxx" --role-arn "arn:aws:iam::12344566:role/xxxxx"

Answer 1

The most likely problem that causes this error is a permissions issue. i.e. something wrong in the definition of the IAM role you passed to --role-arn. You may want to double check that the role and its permissions were set up properly as described in the doc.

Answer 2

You need to update the trust policy of your IAM role so that it gives permissions to the logs.amazonaws.com service principal to assume it, otherwise CloudWatch Logs won't be able to assume your role to publish events to your Kinesis stream. (Obviously you also need to double-check the permissions on your role to make sure it has permissions to read from your Log Group and write to your Kinesis Stream.)

It would be nice if they added this to the error message to help point people in the right direction...

Answer 3

If your Firehose is active status and you can send log stream then the remaining issue is only policy.

I got the similar issue when follow the tutorial. The one confused here is Kinesis part and Firehose part, we may mixed up together. You need to recheck your: ~/PermissionsForCWL.json, with details part of:

....
"Action":["firehose:*"], *// You could confused with kinesis:* like me*
"Resource":["arn:aws:firehose:region:123456789012:*"]
....

Answer 4

When I did the tutorial you mentioned, it was defaulting to a different region so I had to pass --region with my region. It wasn't until I did the entire steps with the correct region that it worked.